The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: scottnds on December 18, 2016, 09:55:13 PM
-
Hello
I need to replace the upper right lane rollover switch.Switch 75.
The manual says it is 5647-12693-19 which is the same as the DIG rollovers.But after buying one and soldering the new one in I found the wire needs to be bent to fit. So after mucking around with it I snapped the wire off.
Does anyone know the number of the correct switch so I can order one?
Thanks
Scott.
-
Hello
I need to replace the upper right lane rollover switch.Switch 75.
The manual says it is 5647-12693-19 which is the same as the DIG rollovers.But after buying one and soldering the new one in I found the wire needs to be bent to fit. So after mucking around with it I snapped the wire off.
Does anyone know the number of the correct switch so I can order one?
Thanks
Scott.
What is wrong with the old switch?
-
I have a problem with the skill shot not working all the time.So my approach was to just change out switches to see if the problem goes away.It may not even be this switch but I have to start somewhere.
-
I have a problem with the skill shot not working all the time.So my approach was to just change out switches to see if the problem goes away.It may not even be this switch but I have to start somewhere.
You can transfer the switch actuator from the old switch to the new one.
Test it in the switch test
-
Sounds more like the original switch might need adjusting if it was working some times. Try rolling a ball over it it switch test and also pushing with your finger.
-
Thanks for the help. I have been really slack and just tried to swap over the actuator and it does not fit on the other switch. I will have a play around in switch test mode as suggested.Thanks again.
-
I have revisited this problem as it is now constant. Before the ball is launched when I press either flipper the score advances 800,000 points from each press. Can anyone point me in a direction? Thanks
-
You could just keep flipping and get a huge score! &&
Does the score go up if you bump the cabinet and not flip? Is it the vibration doing it? If it does that would make me think a loose wire on a switch.
-
I think i may have had a similar problem, mine turned out to be dirty optos on the drop targets.
-
Thanks guys. Its been too cold in the shed but just had a look and have gone over it several times and cannot find a loose wire. There is no score when banging on playfield and the skillshot is intermittent. I still get a score with every fiipper flip. I will clean all optos and see how that goes. Cheers
-
I have fixed it now I hope. I cleaned all the optos but then found a globe holder for the "c" drop target had fallen off the green board and was resting in a wire loom. I must of looked at that thing 20 times and not noticed it was missing. Re soldered the lamp holder back to board and seems to be OK. Thanks for the assistance.