Bally outhole kicker assembly ( suit fathom / embryon etc)

[wiredoug]

I am hunting for a complete outhole kicker assembly for a fathom ..

happy to consider complete broken units.


it looks like this as far as i can tell - http://img-f.pinside.com/201302/661746/74040-i.jpg

[Strangeways]

The plastic part is NLA, however, look here - http://aussiepinball.com/index.php?topic=11490.15. Swinks has sent me a prototype which looks very good.

The ENTIRE assembly would be difficult to track down, but you might be able to source the spares.

[pinball god]

Sorry doug if I'm mistaken, but didn't swinks make a sample for Nino on his 3d printer. Check his thread as I don't know if there were any issues.

[wiredoug]

Yeah i need the complete assembly .. some numbnuts has put a zaccaria one in this and it works 3 times out of 5 then sticks.   a hunting we will go ...

[swinks]

I made a simplistic one for Nino to possibly check, which once proven I can supply 2 versions:
- one on my printer without the ribbing, more blockish
- the other like the original but this will have to be printed at Shapeways as I can't cleany support all the ribbing.

either way the plastic component can be reproduced…..

Nino does a sleeve like what goes in a coil run inside of this?
What size is the rod that slides through

I can always create a upgraded one to house a modified coil sleeve so it will run smooth for a long time…

just let me know if you need my help, as I already have the arm modelled up, see below.

[wiredoug]

thanks .. i need to find the rest of the assembly then see what state its in

[swinks]

I did a sample tonight of this with larger radius in the corners from the centre rib to outer edges to solve the over hanging printing issue and worked well, slightly stiffer than the original component.

Does someone have a assembly drawing for this component - would like to see the part number but also better understand the assembly a little better.