The Aussie Pinball Arcade
Aussie Pinball Forums => General Discussion => Non-pinball (other coin opp) => Topic started by: ktm450 on May 15, 2013, 11:16:28 PM
-
I am currently building a Hankin cocktail clone, I know the height is adjustable on the original cabs, but I was wondering what the best height from the floor to where the glass top should sit before I go drilling holes.
Thanks in advance.
-
depends on your height and build.. thats why they are adjustable.
i think it was you i measured them for in a post elsewhere .. (its set at 685 if it wasnt you.)
do you want the spacings of all the other holes on the original legs then you can drill them all.
-
Thanks for that, I have already drilled and welded up the legs. I found some measurements for those on AA