The Aussie Pinball Arcade

Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: scozza on May 09, 2016, 07:45:17 PM

Title: Williams Hotline EM ball count unit question
Post by: scozza on May 09, 2016, 07:45:17 PM

Well it seems my HotLine restoration is going to keep me busy for quite a while :-)  I suspect I had a spring missing from the ball count unit so I popped a temporary one on there and it seems to have improved the situation but I would like to confirm that I have done the right thing.  Could any kind soul with a similar EM have a look at the photos attached and let me know if I have got the spring in the right spot?

Cheers,

Scott.

Title: Re: Williams Hotline EM ball count unit question
Post by: ralph67 on May 23, 2016, 03:03:27 AM

I think the lower spring is in the wrong spot , take a look at this pic , you will see it should go to the hook shaped part ,
Hope that made sense

Title: Re: Williams Hotline EM ball count unit question
Post by: ralph67 on May 23, 2016, 03:06:24 AM

Not sure, but you may be missing a small spring too , i'll check on some williams steppers i have in the shed , i'll get back to you ...