The Aussie Pinball Arcade

Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: pinball god on February 13, 2016, 10:21:40 PM

Title: ball target issue
Post by: pinball god on February 13, 2016, 10:21:40 PM

This has never happened until I have replaced the targets with new repros. What happens is the metal target guide slips out of the slot it slides up and down in. An easy temp fix but has happened twice now but unsure if its the same target on this bank or not. Definitely the same target bank though. Is there something I can adjust?

Title: Re: ball target issue
Post by: Strangeways on February 13, 2016, 10:40:54 PM

The coil stop needs to be loosened and re-tightened after moving it slightly lower. There's too much travel for the plunger. This happens when the plunger and coil are worn.

Title: Re: ball target issue
Post by: pinball god on February 13, 2016, 11:34:15 PM

Quote from: Strangeways on February 13, 2016, 10:40:54 PM

The coil stop needs to be loosened and re-tightened after moving it slightly lower. There's too much travel for the plunger. This happens when the plunger and coil are worn.

thanks mate will get onto it either via adjustment or get ready for an rtbb order and visit from me.