« previous next »
Pages: [1]   Go Down

Author Topic: Removing and fitting new bulls eye targets  (Read 155 times)

0 Members and 1 Guest are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Removing and fitting new bulls eye targets
« on: June 02, 2010, 01:05:38 AM »
worst case if you are unable to source a press you could post them to me and i can fit the rivets for you,
i have one like the one listed on pin restore, i bought the kit from pin restore and the press was bought from a local supplier.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1]   Go Up
« previous next »