The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: andtan on February 18, 2014, 11:07:44 PM
-
I've started to clean up my WH20 Lost Mine popper and have found that it has a dodgy bell armature fitted which isn't really going to work.
The correct part number for this item is 02-4672 but there doesn't appear to be anyone who stocks them. Does anyone know of a suitable alternative that I can use, even if I have to cut the plastic extension down to the correct size?
As I don't even have an original one, I can't provide the measurements. I've done a search of the internet and can't find any info as to it's length, or even if the part number actually describes the dimensions.
Cheers,
Andy
-
Well I have had replies from Bay Area Amusements and Marco Specialities advising that an alternative armature and extension is an 02-4668. This is armature that is used on the multi-ball popper. They both advised that the plastic extension needs to be cut down and the ball popper cap attached.
Unfortunately they don't have details of the length of the extension. Can someone with a WH20 possibly measure the length of the plastic extension from the join to the base of the ball popper cap?
Cheers,
Andy
-
Andy leave it with me I will get some measurements over the weekend if you like..
-
got keen and measured,
86.5mm from nylon internally threaded tip to flat on the Bell cup.. this does not include the riveted end..
Nylon tip itself is 25mm
-
Thanks heaps TUF,
I wasn't looking forward to doing it by trial and error *.*
The new armature 02-4668 arrived today (I ordered it on Wednesday from Pinball Spare Parts - so quite quick) and it's 97.65-mm long, so I only have to cut 11-mm off.
Cheers
Andy
-
Thanks again TUF, ^^^
One armature cut down and fitted to the Lost Mine popper.
-
Ahhhh, can you feel the love?
Love a good end result, well done lads.
-
Thanks again TUF, ^^^
One armature cut down and fitted to the Lost Mine popper.
Nice work mate!