Author Topic: Pinball 2000 power \ driver board fault fiding & mistakes in schematics  (Read 2908 times)

0 Members and 1 Guest are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
  • Melbourne, Vic
Re: mistakes in Pinball 2000 schematics
« Reply #15 on: June 16, 2011, 11:45:07 PM »
I managed to use an old amiga computer monitor for a test monitor. It's not good enough to play a game on but it does do the job.
I will need to sit a mirror in front of it so the image is not mirrored.
....or you could swap the Horizontal-Yoke wires on the monitor neck, to do the mirror-flip, or even put the wires thru a switch so you can revert to using the monitor normally for anything else ;-)

MM
good point, This monitor has only been used 1once or twice over the last 10 years and I don't have much use for it other than this so i think i will do the conversion to it. ^^^
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)