Once the glue had dried I then had to primer/fill the areas I had glued, and also any cracked areas in the paint. I used acrylic primer filler, out of a spray can, but I hand brushed the paint in rather that spray it on, same as I did on my Dracula PF.
The 2nd pic shows the left 4 bank drop target area which was the worst area that had lifting plywood. I sanded the PF first in these areas with 320 grit sandpaper before putting the primer filler on. These areas would be later block sanded back level with 400 wet/dry paper, and reprimering to fill the areas again if needed.
