Ok, im gonna have a crack at this 
The crimping part i can do, now, as for soldering......is there anything i can really screw up? ill take a *clear* pic and just do the same i guess. I have one of those butane irons, is this acceptable for the job? Thanks guys.
Also, have you checked the PPB board like I mentioned? The Power Supply plug shown is pretty bad, so would be a good idea to check this also... and while both boards are out, re-solder all of the pin headers on both boards - they are prone to dry joints.
Ok, not as yet on checking PPB. This may sound rather silly, but which one is that? Also, do i need to take out 2 boards? I thought only 1 needed to come out. The bottom "off" coloured plug is the power connection i need to tend to. Apologies for my noobieness Owen.
