Here's a few snaps of todays progress.
First up I needed to put the BB on cab and check mounting as the cab piece had a fair banana curve to it,
should have done this before any paint but forgot at some point, anyways as you can see from pic this looks
pretty ugly. Looks as though closest point is down a lot but actually was only down a fraction was the other side
up by around 3mm and then a big bow in middle. Must have always been like this as my new piece of ply was as
square as a buterbox (whatever the hell that is) and when I glued it in I had to clamp each side vertically pretty hard
to bring up flush. Was happy when I worked out there would be sanding involved to rectify as opposed to bogging up the
seemingly low side.
