« previous next »
Pages: [1]   Go Down

Author Topic: ball target issue  (Read 578 times)

0 Members and 1 Guest are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: ball target issue
« on: February 13, 2016, 10:40:54 PM »
The coil stop needs to be loosened and re-tightened after moving it slightly lower. There's too much travel for the plunger. This happens when the plunger and coil are worn.
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1]   Go Up
« previous next »