The Aussie Pinball Arcade

Aussie Pinball Forums => Pinball Trader => Parts wanted => Topic started by: The pinballist formally known as Dean Morgan on October 16, 2009, 08:58:52 PM

Title: Williams old target assy part needed
Post by: The pinballist formally known as Dean Morgan on October 16, 2009, 08:58:52 PM

Hi All,

Can anyone assist with early Williams solid state 1978-80 type targets banks.

I require only the plunger and plate that pulls up to reset the targets.  This is for the 5 Target bank on a Williams Time Warp.  This bank has two coils.


Any help appreciated.  THANKS DEAN

Title: Re: Williams old target assy part needed
Post by: ddstoys on October 16, 2009, 09:39:47 PM

Ill take a look dean im sure ill have one here ^^^

Title: Re: Williams old target assy part needed
Post by: The pinballist formally known as Dean Morgan on October 17, 2009, 09:03:46 AM

Quote from: ddstoys on October 16, 2009, 09:39:47 PM

Ill take a look dean im sure ill have one here ^^^

Excellent thanks Daniel,  do you need a pic of the parts Im after?

Title: Re: Williams old target assy part needed
Post by: FirePower on October 17, 2009, 10:03:35 AM

I just had a look under my TW and the 5 bank is made up of a three bank and a two bank tacked on the end, so as you say there are two coils to reset but there are also two separate plates to lift the drops not one long five plate. Whilst they act together in game play they physically lift independently. If you need I can photograph or measure and sketch them up. 

Title: Re: Williams old target assy part needed
Post by: ddstoys on October 17, 2009, 12:13:23 PM

Sorry Dean
               The part i had pictured is off a Gottlieb drop target bank Sorry