The Aussie Pinball Arcade

Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: pinball god on September 18, 2015, 07:36:20 PM

Title: rfm video amp project
Post by: pinball god on September 18, 2015, 07:36:20 PM

For my video amplifier project on a rfm pinball. I thought I had saved a couple of these cables but cannot find anywhere. They are the red/yellow/black adapters that you use to plug into a spare plug from the pc case power supply and it would be an adapter to plug into a 3.5inch floppy drive. So it had a larger end to plug into the power supply and a smaller plug the other end for the floppy drive.

 Would anyone have one or two lying around they don't want? Much appreciated if you do. This will quickly enable me to tap into a 5v source for the video amp. Thanks

Title: Re: rfm video amp project
Post by: pinball god on September 21, 2015, 09:32:53 PM

Found jaycar have molex plugs and pins. Can someone advise whether the red wire on the molex plug is 5v on a pc

http://www.aaarpinball.com/RFM/IMG_5342.jpg

Title: Re: rfm video amp project
Post by: ddstoys on September 24, 2015, 12:43:53 AM

PC power supply the red is 5v and the yellow is 12v mate

Title: Re: rfm video amp project
Post by: pinball god on September 24, 2015, 08:52:40 AM

Thanks mate. Btw is there any particular size of wire required for video interface? I need to buy some for the interface cable.