The Aussie Pinball Arcade

Aussie Pinball Forums => Pinball Trader => Parts wanted => Topic started by: millsy on January 20, 2009, 12:46:53 AM

Title: Grubb screws & Replay wheel
Post by: millsy on January 20, 2009, 12:46:53 AM

Anyone got any spare grubb screws to fit this flipper linkage also after a 60s Bally Replay wheel (Only need the wheel).
millsy

Title: Re: Grubb screws & Replay wheel
Post by: dj10555 on January 20, 2009, 01:18:32 AM

I have seen pack of grub screws for sale at Bunnings. You might also get them from an Auto shop.

Title: Re: Grubb screws & Replay wheel
Post by: Strangeways on January 20, 2009, 09:38:26 AM

I might have the grub screws and some pawls as well. I'll check tonight !

Title: Re: Grubb screws & Replay wheel
Post by: Retropin on January 20, 2009, 09:09:41 PM

Ive got the wheel downstairs - couldnt remember who i was supposed to give it to!!!

Ok, so i need to start writing stuff down.

Give me your address again and ill post it tomorrow

Title: Re: Grubb screws & Replay wheel
Post by: Strangeways on January 20, 2009, 11:31:54 PM

OK - I didn't find it tonight Millsy - I'll look again tomorrow.

Title: Re: Grubb screws & Replay wheel
Post by: millsy on January 21, 2009, 12:16:46 AM

will PM my details
Thanks Guys
Kev

Title: Re: Grubb screws & Replay wheel
Post by: Strangeways on January 26, 2009, 02:44:08 PM

Found one for you Millsy !

I have the pawl and two grub screws.

If you need a plunger - I might have some NOS ones if you can PM or just post the measurements of the plunger.

Title: Re: Grubb screws & Replay wheel
Post by: millsy on January 26, 2009, 08:10:00 PM

the pawl and  grub screws will be fine thanks,plunger is ok
Millsy