The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Equipment => Topic started by: delarge on September 21, 2014, 08:00:21 PM
-
Hi all,
I started my own LCD screen mod for my AC/DC Pro last year and had a Raspberry Pi connected playing video on loop. I'd just about completed my working prototype and then the project stalled. I've now decided I should finish what I started. Could someone please point me in the right direction on which grade wire to use or a Web address? I have the connectors ready to go, just need to extend the wiring from up the back of the playfield to the power source.
Cheers!
Adam.
-
what is the power you need to the mod and amps
-
Hey Jady,
Raspberry Pi is 5.25V 2A. LCD screen is 12V.
Cheers!
Adam.
-
18 gauge or metric similar 19 x 0.193mm.
My leads for the creature mod are the metric option and will easily take the 12 volt.
-
Thanks, Jady. Will pull my finger out and get this happening now.
Cheers!
Adam.