The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: wonder on January 11, 2009, 12:51:23 PM
-
All this talk about t2 have made wont to finish this one a got a while back(no comment from mark)Received it with no coils and all brackets bent and wires cut,parts missing, project machine.
Having trouble with the ball popper as not sure that when you put the roll pin in to hold the cap to the rod, should the cap be able to move up at all as there is a slot allowing for this, but when i put the roll pin in it locks it up so no movement at all.Is this right or should i have some up wards movement in the cap, when in machine.
When ordering the parts the only thing i didn't get was the roll pin 3/32 x 1/2 but I'm petty sure i got the right one for the job.
So could someone check to see if they can lift there ball popper cap up when on the machine.
thanks
Craig
-
give me a call monday mate
we will start on your new pin and have a couple of boxes of parts to send too
plus a few other bits ....
-
thanks mark
just trying to make some room,but a least this one will be working. ^^^
Just got to work out a way to sneak it in #@#
-
From memory, there should be a tiny spring that sits between the cap and the main plunger. Three sleeves are also placed over the top of the cap shaft, to prevent the clip from being dislodged..
Hopefully I have not confused myself, but that's the configuration on DE VUKs.
-
all done now, will work fine now i have the right pin and not trying to jam something that to big into the hole &^&