« previous next »
Pages: 1 [2] 3 4   Go Down

Author Topic: SLACK transport company  (Read 1099 times)

0 Members and 1 Guest are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: SLACK transport company
« Reply #15 on: March 26, 2009, 10:43:55 PM »
my god man
now that was a nightmare.
i did see a driving arcade video game a couple of weeks ago going cheap on ebay (well half of it was) the seat half of the machine was stolen or lost in transit.
so all he had was the stearing wheel half, which with the way it was made it would have been near impossible to play without sitting down.


Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline ktm450

  • Trade Count: (+1)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong, Victoria
Re: SLACK transport company
« Reply #16 on: March 27, 2009, 04:09:04 PM »
Lucky you could actually track that one down arcadoz  ^&^
Logged

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: SLACK transport company
« Reply #17 on: March 27, 2009, 04:27:00 PM »
it would be so much easier if still i lived in melbourne.
i would just latch a trailer to the car and pick up my pin.
the worst thing now is that it will be raining most of next week so on with the tarps.
then im sure the tarp will start flapping away when im on the motorway.
so ill have to pull up under a bridge and tie it all down hopping  to the all mighty pinball god that the water hasn't got to the wood or electronics.
owe well gives me time to make more room in my garage for it.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline MartyJ

  • Trade Count: (+4)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Melbourne
Re: SLACK transport company
« Reply #18 on: March 27, 2009, 04:35:53 PM »
Its not so good living in Melbourne and within a driving distance to Mark & Geoff's....Always seem to be buying pins and when I'm not I am down there looking at my next purchase!

Anyway, last time I picked on up, it was a rare day and a little bit of rain in Melbourne.  Mark kindly wrapped the machine in plastic - looked like a jumbo roll of gladwrap...round and round up and down on the pin.  I then had a couple of tarps of it too.  Tarps got wet on top, dry as underneith.  Probably didn't need the plastic but you dont want water on a machine....!

Good luck
Logged

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: SLACK transport company
« Reply #19 on: March 27, 2009, 04:41:02 PM »
unfotunatly its about a 100k round trip to the depot and back.
but its a lot cheaper for me to pick it up then to ship it from brisbane to here.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline ajlaird

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Greensborough, Melbourne
  • Go Ahead, Make My Day
Re: SLACK transport company
« Reply #20 on: March 27, 2009, 07:24:06 PM »
It was raining when I picked my pins up, too. A big tarp plus some blocks of wood to lift the pins off the tray did the trick.
Logged

Offline arcadoz

  • Trade Count: (0)
  • ***
  • Forum Posts:
    • Country SA
Re: SLACK transport company
« Reply #21 on: March 27, 2009, 09:58:05 PM »
Quote from: ktm450 on March 27, 2009, 04:09:04 PM
Lucky you could actually track that one down arcadoz  ^&^

Yes, big breakthrough was a courier's signature that was actually legible!
Another annoyance was the machine passed within 1Km of where I lived and travelled a further 40 Kms to their depot. ^&^
Logged
EM score motors wanted- nonworking, broken, burnt, etc..

Marty Machine

  • Guest
  • Trade Count: (0)
Re: SLACK transport company
« Reply #22 on: March 27, 2009, 10:21:09 PM »
i hope i never have to go thru an epic journey to retrieve a pin...

It's pretty bad when the seller practically has to fit a temporary GPS transmitter beacon inside the pin so you have 1/2 a chance of tracing it's wherabouts ;-(

MM.
Logged

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: SLACK transport company
« Reply #23 on: March 27, 2009, 11:31:59 PM »
looks like i will be picking up 2 pins on monday.
just scored another project pin.
bought it from brisbane.
williams jokerz
you all probably saw it on ebay
actually make it 3 pins.
my nephew has a last action hero he wants me to restore.
i will be picking it up from the gold coast.
no more pins for me for a few months.
i now have 4 pins to restore.

Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline MartyJ

  • Trade Count: (+4)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Melbourne
Re: SLACK transport company
« Reply #24 on: March 28, 2009, 08:46:00 AM »
Quote from: Beaky on March 27, 2009, 11:31:59 PM
looks like i will be picking up 2 pins on monday.
just scored another project pin.
bought it from brisbane.
williams jokerz
you all probably saw it on ebay
actually make it 3 pins.
my nephew has a last action hero he wants me to restore.
i will be picking it up from the gold coast.
no more pins for me for a few months.
i now have 4 pins to restore.



LAH rules!  I did mine up, but sadly sold it for a Getaway.  My missus is still angry at me for it!
Logged

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong
Re: SLACK transport company
« Reply #25 on: March 28, 2009, 02:55:58 PM »
No Beaky its no easier living near Marks and Geoffs as each time i leave i'm still thinking i want to fit one more on the ute while im here lol.  But with 4 pins to restore you should be busy for a while now
Logged

Offline v8racefan

  • Trade Count: (+2)
  • ******
  • Forum Posts:
    • Gold Coast Queensland
Re: SLACK transport company
« Reply #26 on: March 29, 2009, 12:15:07 AM »
hey beaky was the jokerz from max driller aka All pinball in morningside, brisbane?. I hope this transaction goes well, plenty have been burnt! !@#
Logged
Pinballs in my collection Elvira, Stern Grand Prix, Bally Corvette, Creature from the Black Lagoon, Judge Dredd, Black Rose and Data East Guns n Roses.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: SLACK transport company
« Reply #27 on: March 29, 2009, 05:49:49 AM »
yeah it was, well sort of, the pin is owned by another fellow who i have spoken to he just got max to list it for him.
plus it was bought as a project.
 i will keep you informed on how big the fire is (the bigger the fire the worse i get burned)
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: SLACK transport company
« Reply #28 on: March 30, 2009, 11:22:55 AM »
pinbot has finaly arrived at the transport depot $#$
now ive got to go and pick it up & yes it is raining ^&^

Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline v8racefan

  • Trade Count: (+2)
  • ******
  • Forum Posts:
    • Gold Coast Queensland
Re: SLACK transport company
« Reply #29 on: March 30, 2009, 03:55:20 PM »
bugger its forecasted to rain all week in brisvegus??
Logged
Pinballs in my collection Elvira, Stern Grand Prix, Bally Corvette, Creature from the Black Lagoon, Judge Dredd, Black Rose and Data East Guns n Roses.
Pages: 1 [2] 3 4   Go Up
« previous next »