Aussie Pinball Forums > Handy hints and tips

WPC Sound Board Interface Error and no Fliptronics

(1/1)

Maxprofits:
Hello all,


Been a very long time since I had time to do much pinball stuff. Anywho, I'm hoping that is changing.


I am in the process of resurrecting my much neglected TZ. During this process I found a fault that I haven't came across before and could not find much about online either.


Fault symptoms were, one bong on boot up and then no sound at all after that. Test would report "sound board interface error", switch tests would not see anything associated with the fliptronics board (no flipper). The display was unaffected.


After some fault finding I eventually swapped CPU boards and all faults disappeared (fault was on the TZ CPU board).


Some further research showed the U3 on the CPU was the likely offender.


Replaced U3 (74LS245), reinstalled CPU board and the fault was cleared.


I post this in the hope that if someone else experiences a similar fault, this post will help them.


Cheers,


Dan

ddstoys:
Nice work getting it sorted and thanks for sharing your results to help others


Sent from my iPhone using Tapatalk

Boots:

--- Quote from: Maxprofits on July 26, 2021, 07:19:21 PM ---Hello all,


Been a very long time since I had time to do much pinball stuff. Anywho, I'm hoping that is changing.


I am in the process of resurrecting my much neglected TZ. During this process I found a fault that I haven't came across before and could not find much about online either.


Fault symptoms were, one bong on boot up and then no sound at all after that. Test would report "sound board interface error", switch tests would not see anything associated with the fliptronics board (no flipper). The display was unaffected.


After some fault finding I eventually swapped CPU boards and all faults disappeared (fault was on the TZ CPU board).


Some further research showed the U3 on the CPU was the likely offender.


Replaced U3 (74LS245), reinstalled CPU board and the fault was cleared.


I post this in the hope that if someone else experiences a similar fault, this post will help them.


Cheers,


Dan

--- End quote ---

Did you put the old board back in before replacing U3?
I have seen this rectified by reseating the ribbon cable.

Navigation

[0] Message Index