« previous next »
Pages: [1]   Go Down

Author Topic: SYS11 B&C power supply, AUX, and interface PCB overhaul (corrosion damage)  (Read 3186 times)

0 Members and 1 Guest are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: SYS11 B&C power supply, AUX, and interface PCB overhaul (corrosion damage)
« on: August 17, 2011, 01:08:24 AM »
On the solder side there was a lot of corrosion under the solder mask so that will have to be removed to ensure it doesn't proceed further.

On the parts side there are a few small spots that needed attention
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1]   Go Up
« previous next »