The Aussie Pinball Arcade
Aussie Pinball Forums => General Discussion => Non-pinball (other coin opp) => Topic started by: ddstoys on December 02, 2012, 10:43:17 AM
-
Hi guys
I'm trying to modify my touchscreen jukebox at the moment you use the screen to turn the page but to use that option there is also an option that allows people to skip songs so the plan is to add two buttons to turn the pages.
Does anyone know of a cheaper or easy way to do this. I don't really want to spend $70 on a keyboard encoder with 30 inputs when I only need 2
Ill go that road if no one know any other options
Thanks
-
What about hacking an old mouse - that'll give you 2+ buttons with a USB connection at the other end. You might need to look through a few to find a layout to which you could solder, but should be cheap enough.
Alternatively, you could do a gamepad/controller hack.
-
About $15 including post:
http://www.ebay.com.au/itm/New-Zero-Delay-Arcade-USB-Encoder-PC-to-joystick-for-MAME-Fight-Stick-Controls-/170944764699?pt=LH_DefaultDomain_0&hash=item27cd1a1b1b
New Zero Delay Arcade USB Encoder PC to joystick for MAME & Fight Stick Controls
Packing Includes
1 x USB Cable
4 x Wire Sets for Joystick (UP/DOWN/LEFT/RIGHT)
8 x Wire Sets for 8 Buttons. (The encoder allows for four additional button inputs)
1 x Instructions
-
I'm not sure 'where' you would solder in 2 buttons to replace the function(s) of a touchscreen?
You'd need some kind of intelligent controller that has 2 button inputs and can generate touchscreen co-ordinates, and then you'd need to make sure it would interface into your existing touchscreen controller, more than likely it's not usb and a direct drive instead.
-
Thanks for the replies I hacked up a USB keyboard which seems to work. The jukebox program had options for use with keypad Marty.
The encoder I bought for the job was advertised as a keyboard encoder but looks like its a joystick encoder and the jukebox program Only recognises keyboard strokes
-
My next suggestion (if it uses usb) was to hack apart a usb keyboard, and just use 2 buttons wired in the wiring matrix, but obviously you've now done that ;-)