The Aussie Pinball Arcade

Aussie Pinball Forums => Pinball Trader => Parts wanted => Topic started by: pinball god on February 21, 2016, 06:55:15 PM

Title: power rectifier standoffs
Post by: pinball god on February 21, 2016, 06:55:15 PM
Could someone advise where I can get a couple of these. Noticed on my embryon two of these where broken on the rectifier pcb. They hold in place the plastic protector sheet. Thanks
Title: Re: power rectifier standoffs
Post by: Strangeways on February 24, 2016, 05:15:49 PM
These hold the plastic shield above the PCB. Unobtainium  *.*
Title: Re: power rectifier standoffs
Post by: Toads on February 24, 2016, 08:22:50 PM
That's a job for mr swinks and his 3D printer.
Title: Re: power rectifier standoffs
Post by: pinball god on February 24, 2016, 08:27:44 PM
Quote from: Strangeways on February 24, 2016, 05:15:49 PM
These hold the plastic shield above the PCB. Unobtainium  *.*
bugger so their not made of unobtainium.
Title: Re: power rectifier standoffs
Post by: solar value on February 24, 2016, 10:55:48 PM
From memory the three parts are not all the same. Two of them are like hinges and one is a clip. The clip is available from Marco Specialties:

http://www.marcospecialties.com/pinball-parts/M-1829-3

I haven't found the hinges anywhere but would also like some. If the good one you have is a hinge maybe you could send it to Swinks to be reproduced.
Title: Re: power rectifier standoffs
Post by: Strangeways on February 24, 2016, 10:59:56 PM
Quote from: solar value on February 24, 2016, 10:55:48 PM
From memory the three parts are not all the same. Two of them are like hinges and one is a clip. The clip is available from Marco Specialties:

http://www.marcospecialties.com/pinball-parts/M-1829-3

I haven't found the hinges anywhere but would also like some. If the good one you have is a hinge maybe you could send it to Swinks to be reproduced.

That is the exact part !