The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: pinnies4me on April 29, 2012, 03:42:25 PM
-
Picked up a backglass for my Firepower, but it's not fitting my head box. Is there a special technique for removing the metal lift channel from an early 1980's Williams backglass? I have applied tight pressure to see if it slides off, but it's tight and I am afraid of shattering the glass.
It's slightly off centre, about 3 or 4 mm to one side sticking out, so needs to be repositioned to go into my game.
Any thoughts?
-
They are held in place with double sided tape... you need to carefully slide a craft knife along the length on both sides to cut through the tape... normally its one piece in middle and one on either end
-
Thanks Gav