The Aussie Pinball Arcade

Aussie Pinball Forums => Technical Matters => Equipment => Topic started by: delarge on September 21, 2014, 08:00:21 PM

Title: Wiring for mods
Post by: delarge on September 21, 2014, 08:00:21 PM

Hi all,
I started my own LCD screen mod for my AC/DC Pro last year and had a Raspberry Pi connected playing video on loop. I'd just about completed my working prototype and then the project stalled. I've now decided I should finish what I started. Could someone please point me in the right direction on which grade wire to use or a Web address? I have the connectors ready to go, just need to extend the wiring from up the back of the playfield to the power source.

Cheers!
Adam.

Title: Re: Wiring for mods
Post by: swinks on September 21, 2014, 08:05:27 PM

what is the power you need to the mod and amps

Title: Re: Wiring for mods
Post by: delarge on September 25, 2014, 03:39:16 PM

Hey Jady,
Raspberry Pi is 5.25V 2A. LCD screen is 12V.

Cheers!
Adam.

Title: Re: Wiring for mods
Post by: swinks on September 25, 2014, 08:50:57 PM

18 gauge or metric similar 19 x 0.193mm.

My leads for the creature mod are the metric option and will easily take the 12 volt.

Title: Re: Wiring for mods
Post by: delarge on September 25, 2014, 08:52:28 PM

Thanks, Jady. Will pull my finger out and get this happening now.

Cheers!
Adam.