The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Handy hints and tips => Topic started by: PinPal on December 03, 2017, 09:21:34 PM
-
Had a bit of trouble putting new super bands on my Flash Gordon flipper bats.
I found if you pop them in a cup of boiling water for a couple of moments it makes them more easier to slip over the flipper bat.
But dry them first, %.%
Pinpal.....
-
Neat trick. Do they return to the original elasticity ?
-
Good tip - they are buggers to get on. You are almost there, the end slips off and you lose some skin ^.^
-
Good tip - they are buggers to get on. You are almost there, the end slips off and you lose some skin ^.^
I'll second that, good once you get them on though.
-
there near impossible to put on stern top lane rollovers (on metallica especially) I got two on and gave up on the rest. Did hot water, microwaved them in hot water and those mini rings are buggers. Anyone succeed easily with these
-
Throw them away and buy titans.
-
The yellow bands I put on Flash Gordon look neat, the lamps under the return lanes make the bands glow.
Awesome ^^^
Pinpal...
-
Throw them away and buy titans.
Tried Titans on a couple machines. didn't last long.
-
Throw them away and buy titans.
Tried Titans on a couple machines. didn't last long.
Why is that? are they made from a different compound. Super bands and stern lane guides hate each other or I have weak fingers lol. I swear I had to stop after a few as my fingers just gave out.
-
Throw them away and buy titans.
Tried Titans on a couple machines. didn't last long.
Why is that? are they made from a different compound. Super bands and stern lane guides hate each other or I have weak fingers lol. I swear I had to stop after a few as my fingers just gave out.
Not sure why, but they didn't last on the two machines I installed. Specifically the 2 1/2 on the slings. Chewed through by the sling itself.