The Aussie Pinball Arcade

Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: Bayview on January 21, 2018, 04:32:40 PM

Title: Williams EM Rollover - Which one is normal?
Post by: Bayview on January 21, 2018, 04:32:40 PM

Hi Guys,
 
Cleaning up a Williams 1976 "Toledo'.
I am doing the rollovers, and the first 2 are different to each other.
I would like to know which picture ( A or B) is the correct setup.
Picture A - just has the small washer followed by the lock washer thingy.
Picture B - has 2 extra bigger washers, one under the button between the brass fitting, and another one is put on before the smaller washer.
 
So which one is correct. A or B ? or neither.  !@#
 
Thanks
Bruce

Title: Re: Williams EM Rollover - Which one is normal?
Post by: Strangeways on January 21, 2018, 11:04:37 PM

The Washers are used to adjust the rollover to the correct height ;

These are added for this reason, also to increase the travel of the rollover to activate a switch. There is no wrong or right way to install the washers. I can lookup a parts manual and double check - but I doubt if there's anything definitive.

Title: Re: Williams EM Rollover - Which one is normal?
Post by: Bayview on January 21, 2018, 11:21:01 PM

Ok, cool. Thanks for the reply.
Cheers