The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Pinball Repairs / Problems & Assistance => Topic started by: 48 on May 23, 2010, 02:01:15 PM
-
As the subject says... can someone help me with this one.
I have a couple of machines with older type coin mechs in them.
Vintage is mid to late 70's they use .20c and .10c mechanisms.
What I don't have is the mounting screws for them.
These screws are around 1/2 " long, half thread and half machine round steel with
a slot for screwdriver.
Have looked around different suppliers but can't seem to find them.
I figure someone here will have had prior experience I need about a dozen of these little suckers.
If anyone has any idea where to obtain them it would be greatly appreciated.
Cheers.
-
I think I have a few lying around. PM me your details and I'll post some to you. Might not have a dozen, but it will be a start !
-
I often find one or two in the bottom of old machines when I clean them out <.>
cheers
Ian
-
Will be sent in tomorrow's post !
-
Many thanks to Nino for helping me out with this.
There are some really good people on this site.
Cheers,