The Aussie Pinball Arcade
Aussie Pinball Forums => Technical Matters => Handy hints and tips => Topic started by: swinks on July 05, 2011, 09:49:50 PM
-
I just wanted to put some info together as until I had to do some investigation & repair I was none the wiser about the different coils used in a the 90's Bally / Williams games.
I have included some screen shots from some trusted sites to put all the info in one place for others if they end up coming down this path.
Bally / Williams used 5 types of coils defined by 5 different colours and part no's. When I had a problem with my machine one issue I thought I had was weak power to make the ramp shots on my Whitewater, but with investigating realised that a previous owner put in a weaker coil compared to what was specified in the manual. In my Creature from the Black Lagoon I had one coil too strong which contributes to plastics damage.
Next issue I found was a flipper coil diode was chipped and instead of buying a new coil for $20 plus freight I could get a diode for $0.15 from Jaycar (pack of four for 60 cents). Again it took some searching to discover the correct diode to use but found it was a 1N4007. Jaycar Electronics sell the equivalent ZR1007 which on the pack states Diode 1N4007 1000V 1A. I checked with Skybeaux one of the resident experts to confirm this and ticks all round.
Below attachments show:
- the 5 coil differences and common use
- coil wiring for diode replacement and general check
Please use this info as a guide only, and always refer to your game manual, and if anyone else has any valuable info to add please do so to help others.
-
Nice job! I've been using those Jaycar diodes for years with no issues.