thanks for the support guys, just keeping this post close to the front.

Updated 4-8-12

1st Run as follows:
1 x silver mirror - 0,8mm
1 x black mirror - 0.8mm
1 x gold mirror - 0.8mm


In the colours no one here in Aus does thinner so 0.8mm is the best I can do. So when you are considering, you the customer needs to determine the space - e.g. reading on Pinside machines like The Shadow are so very tight though a few guys persisted but very tight. So you the owner has to make the decision if the blades will fit because as you know machines vary and some may have slight warps etc so I can not accept responsibility for variations of fit. As for fitting to the same profile there are variances in every machine / model so again I can not design a product for every machine rather go for something to fits a large percentage. Almost every Bally / WMS will be the same except near the back board (back of the blade) e.g. a Getaway is slightly different as some guys have had to do some slight modifications to either the timber in the back of the cabinet and others using tin snipes to the blade. I would rather you be well informed rather than upset.


Prices are in for the 1st Run:

Chrome Mirror - $90 a set
Black and Gold Mirror - $135 a set

freighting multiple sets in one package will be a little cheaper per unit in effect so maybe team up with a few guys in your area and share the saving.

Multiple set Special deals per person:
buy 3 sets and get $5 off each set of blades
buy 4 sets and get $7.50 off each set of blades
buy 5 sets and get $10 off each set of blades.