Now for the cabinet repairs. Not a great deal of repair was needed, just tightening a couple of loose joints and filling a few dents/scrapes. The front had a couple of screws with cup washers in it which I promptly removed. I then carefully spread the loose corners with a screwdriver.. just enough to allow some woodglue into the join, then clamped and put in a few nails just for good measure. Same deal for the cross braces in the bottom of the cabinet, a couple of the joins were a bit loose so these were glued, clamped and a couple of nails. Back panel and backbox mount were checked and repaired as needed. I filled the nail holes during the next step covered in my next post.