« previous next »
Pages: [1]   Go Down

Author Topic: funhouse lhs plunger issue  (Read 144 times)

0 Members and 1 Guest are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: funhouse lhs plunger issue
« on: October 03, 2013, 12:25:00 AM »
Check the alignment of the plunger - the plunger rubber should sit dead centre to the shooter lane. Too far to one side will cause the problem you describe. It is adjusted by the three screws on the inside of the cabinet.
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1]   Go Up
« previous next »