« previous next »
Pages: [1]   Go Down

Author Topic: Making a plunger (ball-lane) Notch ???  (Read 705 times)

0 Members and 1 Guest are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Making a plunger (ball-lane) Notch ???
« on: March 21, 2009, 11:33:05 PM »

I don't have the answer, Marty - But when I clean them, I roll some 600 grit around the end of an old billiard cue and sand away the dirt.

I guess you could use a heavier grit ?
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1]   Go Up
« previous next »