« previous next »
Pages: [1] 2 3 ... 5   Go Down

Author Topic: Knocker troubles  (Read 3881 times)

0 Members and 16 Guests are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Knocker troubles
« on: March 25, 2009, 01:36:38 PM »

To check the coil - Set the MM to OHMS, and place the probe on each lug of the coil. You should see around 4 Ohms. Remove the connector to the coil (nearest the coil) - also check the wires are soldered on the coil.
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1] 2 3 ... 5   Go Up
« previous next »