OK Matthew, no problem.
Once you've done the test Nino suggested you then need to test that voltage is getting to the coil.
Ummmmmm ...... how? 
Matthew
One step at a time Mate - 
Lets check the connectors and the coil itself first.
OK, here are the results:
I switched the machine off and disconnected the coil. I then connected a 9V battery to the two terminals on the coil and the kicker fired. I then set my MM to ohms (200) and put one probe on each terminal on the coil, and it displayed 4.4 on the MM. Is that too high?
I reconnected the coil and then checked the IDC connectors (J107 and J130). They looked OK, so I pushed the wires in with a screwdriver and reseated the connectors. The Q68 thingy looked OK to me too. I set the Match level to 50% and played a few games until a Match was awarded, but the kicker did not fire.
Matthew
