« previous next »
Pages: [1]   Go Down

Author Topic: bally pop bumber removal  (Read 1042 times)

0 Members and 1 Guest are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: bally pop bumber removal
« on: April 08, 2009, 06:19:58 PM »
when you go to solder the light socket back on put some cardboard between the wire and under side of the pf so you dont get flux and crap all over it ( the pf that is)
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1]   Go Up
« previous next »