Author Topic: Earthshaker transformer  (Read 1232 times)

0 Members and 3 Guests are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Earthshaker transformer
« Reply #30 on: April 23, 2009, 07:22:47 PM »

Some nasty repair work there.

I would be trimming those tracks that have lifted - they will only curl up and you will have all sorts of problems. Use an exacto knife or similar
Replace those pin connectors
Remove the chips you believe are fried, clean up the solder mess and solder in sockets. Install the chips again - UDN7180 are VERY hard to find, 4049 should not be.
Simply clean up the flux off the repairs - maybe remove the solder and resolder
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia