Author Topic: Buck Rogers restore  (Read 1078 times)

0 Members and 2 Guests are viewing this topic.

Offline Mr Pinbologist

  • Trade Count: (+5)
  • ******
  • High Score Initials:
  • Forum Posts:
  • Wauchope NSW
Re: Buck Rogers restore
« on: May 28, 2009, 09:54:21 PM »
While going over the electricals/ connectors etc I pulled apart the power supply board for an overhaul and found it had been repaired a few too many times with lifting tracks, and was generally in a very bad state, so I designed and built my own power supply, making up my own PCB layout. I stuck with the original +60 volt and –12 volt regulator circuit designs, but came up with my own +5 volt regulator circuit based around an LM338K regulator IC.