Almost Done !

The game plays VERY WELL with no errors, but I plan on playing a few more games to ensure everything is 100%. So for now, it is simply being tested. I have to add a few more improvements, and what I will do ASAP is replace the current power cable. I'm still looking for a new set of slings, even though it is very difficult to see that the RHS is broken - but that's no excuse for leaving it there. I have to install two new door bolts and print & laminate the instruction cards.

So here's a few pictures taken in daylight to "show off" the ramp and the 99% completion of the machine. I've covered most of the processes I've used, so these pictures are the culmination of those efforts. The ramp is the "standout" - I can never look at another Addams with a standard smoked ramp.

Just a recap - these are the parts I've used for this machine. Note that EVERYTHING was bought from Pinball Spare Parts and RTBB - support these guys as they are doing a great job supporting this site and the community in general !

Ramp
Bookcase Base and top
Flipper Kits (2)
Rubber kit
Globes
Aussie Door
Globe Condoms
Chair Cliffy
Purple Posts
Leg Bolts
Blue Target - Heavy Duty
Coil Sleeves
Capacitors
Bridge Rectifiers

Repairs

Special thanks to Angelo (Slammer) for repairing the scoops and metal ramp

Boards - Upgrades completed - no repairs required other than one connector

Tools

Windex
Nifti
Rags
Scotchbrite
Mr Sheen
Novus 2
Meguairs Paste Wax
Flitz

Aoyue 701 Desoldering / Soldering station made board upgrades a Breeze !!

Some pictures of the finished machine (still to be played to iron out any problems)