Author Topic: T2 pop bumper light problem  (Read 300 times)

0 Members and 3 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
  • Melbourne, Vic
Re: T2 pop bumper light problem
« on: November 24, 2009, 06:21:50 PM »
no probs john.

its always good to have a picture of the original setup.
makes it easier to see how it was before it was pulled apart.

before i strip anything off a playfield i always take photos.

makes it easier to figure out where those left over coils or screws belong.  #@#

just like putting together a 500 piece jigsaw puzzle, it makes it easier to assemble when you have the picture on the box to refer to.

and make a backup incase you delete them  ^&^ like poor wonder did.

lol
« Last Edit: November 24, 2009, 06:27:20 PM by beaky »
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)