None of the coin entry plastic bezels were good enough to use, (imo anyway) so i decided to make up some new ones. So what i did was so scan the ones pictured here in the 1st pic, tidy the images up in Photostudio and reverse print them onto clear adhesive. While the ink was drying on the decals, i cut out some pieces of polycarbonate plastic for the new plastic bezel pieces, (2nd pic shows one of them being test fitted with the nylon coin entry sleeve.

I made a fair few of the decals an you can see.. just in case i screwed up and had to start again
Once the decals were stuck onto the plastic i placed some white adhesive label over the main decal to diffuse the light and to protect the decal ink.

last pic shows the end result