Author Topic: Molten Firepower 2 flipper coil  (Read 440 times)

0 Members and 1 Guest are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
  • Melbourne, Vic
Re: Molten Firepower 2 flipper coil
« on: March 10, 2010, 03:53:09 PM »
I think you guys are onto it!!

I noticed the bushing had a bit of slop in it, so will need to make sure its right (i think there may have been some wrong screws in there...), readjust EOS and replace coil once it arrives.

Thanks heaps
a bit of slop is acceptable but to much may also cause playfield damage (the end of the flipper bat will start to drag on the playfield)
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)