Author Topic: Best way to wire flippers? Advice needed?  (Read 398 times)

0 Members and 1 Guest are viewing this topic.

Offline studley67

  • Trade Count: (+7)
  • ******
  • Forum Posts:
  • adelaide hills
    • facebook
Re: Best way to wire flippers? Advice needed?
« on: January 14, 2009, 06:42:18 PM »
i hold certification in mil spec wiring and would never just lay the wire onto the lug.if you can you should at least have a mechanical joint aswell. folding the  pre-tinned wire(s) over the edge of the lug.this also holds the wire in place so you have two hands to solder.one to hold the iron and one to feed in solder to the joint.
Life is too short to spend time with people who suck the happiness out of you