« previous next »
Pages: [1] 2   Go Down

Author Topic: Gottlieb System 3 DMD Issue  (Read 569 times)

0 Members and 3 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Gottlieb System 3 DMD Issue
« on: February 02, 2011, 01:23:34 AM »
+1 on home pin's comment

other than the high voltage have you tested for the +5 & +12 volts?

try putting the freddy rom in the SF dmd controller and then put the SFcontroller in the freddy. ( if the controller board has a rom, not sure if sys3 has display rom)
if it works then try swapping the ribbon cable over.
« Last Edit: February 02, 2011, 01:33:49 AM by beaky »
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1] 2   Go Up
« previous next »