I have fitted the new 5 volt reg and I have +4.97 volts with no load and 4.95 with a load.
I added all the jumpers for the Caps & Bridges
I did a bench test on the G.I. board and it works perfectly.
I have added plenty of solder on all the tracks ( on the G.I. board) . Only 1 or 2 tracks needed the thick solder but I thought I would make them all the same.
After cleaning all the clear paint and flux off the driver pcb (instead of using proper pcb clear lacquer on the board some one used normal acrylic clear so when i cleaned it off it took the green off with it) I added a new coat of clear.
All that is left to do is fit the G.I. pcb to the main pcb and fit it to Leon's machine,
