« previous next »
Pages: [1] 2   Go Down

Author Topic: Learning to solder boards  (Read 3790 times)

0 Members and 4 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Learning to solder boards
« on: June 25, 2011, 04:34:19 PM »
Quote from: mildflame on June 25, 2011, 12:17:48 PM
Yea, nice thin solder, nice thin tip, heat up the pad and wire then slowly feed solder though once you have enough solder, wait a few seconds and take off the heat,
100% spot on.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1] 2   Go Up
« previous next »