« previous next »
Pages: [1] 2   Go Down

Author Topic: WILLIAMS SYSTEM 3-6 TEST BENCH SETUP  (Read 517 times)

0 Members and 5 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: WILLIAMS SYSTEM 3-6 TEST BENCH SETUP
« on: July 19, 2011, 01:38:14 AM »
Quote from: ddstoys on July 18, 2011, 09:53:33 PM
Quote from: Mr Pinbologist on July 18, 2011, 09:12:57 PM
Looks good Daniel  ^^^ i need to build something similar for Wms game boards, same as i did with my own test rig for Bally/Stern/sys1 Gtb displays and driver boards.

Speaking of which.. did you end up using the schematics for mine i sent you ages ago??

I have it half built on my work bench hidden under all the mess  *!@   But when the time comes to work on my own Ballys ill be sure to finish it.   I cheated and went alltek on the repair i was doing way back then !^! !@)
Next time you know to go 'Home pin' If you ever need a new bally mpu board again.
Besides I thought alltek built patios. Oh that's right, they're called Altech with 1 'L'  && 
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1] 2   Go Up
« previous next »