So here is a list of what was done:

-replaced soccer ball
-replaced left ramp
-replaced all coil sleves
-replaced all rubbers
-replaced all star posts
-flame polished ramps
-replaced all decals under ramps
-made all clear plastics out of lexan
-replaced slingshot plastics
-replaced all other plastics that were availiable from Marco
-made plastic protectors for slings and all other venerable plastics
-removed and polished every post and every screw as all had surface corrosion
-a couple of small touchups
-PF completely stripped down cleaned polished and waxed
-new globes
-inserts cleaned from below playfield
-leveled a few inserts
-rebuilt all flippers, new bats, new plungers, links, and pawls. New coil sleeves and flipper bushings
-Replaced all targets except large red ones
-replaced pop bumper caps
-replaced pop bumper wafers
-replaced a few coils that were the incorrect ratings
-re-blued the spring steel flaps on the entrance to all ramps
-replaced all rollover buttons
-replaces all kickout saucer plastics
-all new hex-screws
-replaced lane guides
-replaced lock magnet core
-New leg bolts and levelers
-added 5 new mirror glazed balls
-removed factory mylar with new mylar
A lot of the ramp decals were not available so I had to reuse them I covered it in this thread:

http://aussiepinball.com/index.php?topic=6730.0

Thanks to Tim for letting me use your rivet press mate, made life a lot easier 

Here are a few reassembly photos: