thanks for that. I thought the pinscore power boards would be alright??? game was not firing up at all, got no lights on so thought i would replace the whole power board due to age. It has got the game going as far as attract mode and doing tests etc. first game i played after new board got to 3rd ball and that is when it reset, since then the game resets every time a ball comes out into the torugh and fires. game resets, ball drains back down.
I did change the diode on the ball plunger coil for just in case, found a broke diode on a switch in the ball trough and replaced, but other dioes seem fine, but maybe i should just change them all.
slam tilt, what is this? is the related to the tilt plumb thingy and knocker?????
did a switch test this arvo and switches seemed fine but might re look at that also.
What are the chances I have not seated a cable back onto the new power board causing this issue?
Will see have i go this week then if no luck might pm beaky re kind offer to repair board. Must admit I am scratching my head a little at where to go now.
