The forum software has been updated!
0 Members and 2 Guests are viewing this topic.
Quote from: ktm450 on October 27, 2011, 08:49:11 PMQuote from: beaky on October 27, 2011, 08:38:51 PMand matt if your dmd driver pcb isn't badly heat damaged just rebuild it (HV section). I do these on a regular basis. I replace every component good or bad including bridge rectifiers. (I always do a full rebuild not a partial patch up)but if the board is heat damaged then the homepin board is the way to goNo heat damage luckily, are the components available locally Andrew? I know Great Plains used to sell a kit but I haven't got around to sussing the rebuild out yetI can do you a kit for $14 (no bridges but all the other parts).
Quote from: beaky on October 27, 2011, 08:38:51 PMand matt if your dmd driver pcb isn't badly heat damaged just rebuild it (HV section). I do these on a regular basis. I replace every component good or bad including bridge rectifiers. (I always do a full rebuild not a partial patch up)but if the board is heat damaged then the homepin board is the way to goNo heat damage luckily, are the components available locally Andrew? I know Great Plains used to sell a kit but I haven't got around to sussing the rebuild out yet
and matt if your dmd driver pcb isn't badly heat damaged just rebuild it (HV section). I do these on a regular basis. I replace every component good or bad including bridge rectifiers. (I always do a full rebuild not a partial patch up)but if the board is heat damaged then the homepin board is the way to go
