Thanks for the kind words, guys 

Unfortunately, PinballInc have not remade the ramp set for this title, otherwise, I would have installed them. Lucky for me, they are in reasonable condition and they cleaned up well. Both needed some repairs and I guess the good thing about these ramps is the factory protectors - so there's no damage at all to the ramp entrance on either ramp.

The lower ramp was fine and needed no work.

The upper ramp needed some work around the diverter assembly. The hole that the diverter arm is fitted was badly damaged as seen in this first picture ;





I had some plastic washers that were a perfect fit. So I glued one washer to the top of the ramp and one underneath. This ensures that the diverter arm is steady. I will fit extra washers to raise the diverter assembly so it does not scratch the ramp.





The Upper right hand side ramp had a crack in it. I simply glued the crack, and then made a plastic reinforcement that I will place under the ramp bracket. I won't glue it as the repaired area will lose its transparency. Here's the plastic I used ;





I shaped the plastic just a little bit bigger than the cracked area ;





I'll use a longer machine screw. I also bought a new support post as the original was threaded with a large wood screw 





All that is left is the clearcoat for the gold plated ramp. I switched the game on to test and everything seems to be OK